Simulating Paraffin Wax Deposit Removal: A Numerical Study of SGN Application

Document Type : Research Paper

Authors

1 Department of Rural Engineering, Federal University of Espírito Santo, CCAE-UFES, Alegre, Espírito Santo, Brazil

2 Department of Mechanical Engineering and Energy, Polytechnic University IPRJ-UERJ, Nova Friburgo, Rio de Janeiro, Brazil

3 Simulation and Computational Biology Laboratory, High Performance Computing Center, UFPA, Belém-PA, Brazil

4 Faculty of Mining and Environmental Engineering, Federal University of South and Southeast of Pará, Unifesspa, Marabá, Pará, Brazil

Abstract

Offshore oil exploration encounters numerous challenges, the formation of paraffin wax deposits ranks among them. The Nitrogen Generating System (SGN) emerges as a hybrid technique, utilizing a thermochemical reaction with nitrogen salts to generate heat and facilitate the melting of paraffin wax deposit. Given the substantial heat release during this reaction, a meticulous approach is imperative to prevent potential damage to the oil pipeline. This study focuses on the numerical simulation of an SGN application, addressing the heat conduction problem, by solving a transient two-dimensional heat conduction model with phase change and chemical reaction. Approximately 70% of paraffin deposit was removed after 3 hours of SGN application. After 5 hours of SGN simulation, with a pH level of 4 and initial concentration of 2 mol/l, a liquid fraction of paraffin wax of 0.9 was observed. This result is consistent with other studies, such as thermal washing and active electrical heating techniques. The dynamic behavior of the liquid fraction obtained in simulation also aligns with previous works, showing a nonlinear and decreasing rate of melted paraffin wax. The SGN simulation identified a phenomenon called “heat spike”, in which the chemical reactants are quickly consumed, leading to a sudden temperature increasing. This effect is significantly influenced by the pH level and initial concentration. The findings offer valuable insight into the efficacy of the SGN technique in mitigating paraffin-related issues, highlighting the importance of precise control over reaction variables for optimal results.

Keywords

Main Subjects

Publisher’s Note Shahid Chamran University of Ahvaz remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

[1] Gao, S., Investigation of interactions between gas hydrates and several other flow assurances elements, Energy & Fuels, 22(5), 2008,3150-3153.
[2] Kumar, A., Perspectives of Flow Assurance Problems in Oil and Gas Production: A Mini-review, Energy & Fuels, 37(12), 2023, 8142-8159.
[3] Sousa, A.M, Ribeiro, T.P., Pereira, M.J., Matos, H.A., On the economic impact of wax deposition on the oil and gas industry, Energy Conversion and Management: X, 16, 2022, 100291.
[4] Xu, H., Khan, F., Jung, S., Wang, Q., Probabilistic model for hydrate and wax risk assessment in oil and gas pipelines, Process Safety and Environmental Protection, 170, 2023, 11-18.
[5] Sloan, D.E., Koh, C., Clathrate hydrates of natural gases, CRC Press, Boca Raton, 2008.
[6] Elkatory, M.R., Soliman, E.A., Nemr, A.E., Hassan, M.A., Ragab, S., El-Nemr, N.A., Pantaleo, A., Mitigation and Remediation Technologies of Waxy Crude Oils Deposition within Transportation Pipelines: A Review, Polymers, 14(16), 2022, 3231.
[7] Liu, X.Y., Zhang, N.D., Li, X.Q., Li, C., Yu, P., Liang, G.J., Ma, C., Numerical Simulation of Paraffin Melting in Circular Tube Using Lattice Boltzmann Method, Thermal Science, 26(3A), 2022, 2113-2123.
[8] Jiang, H., Liu, X., Zhao, H., Numerical study for removing wax deposition by thermal washing for the waxy crude oil gathering pipeline, Science Progress, 103(3), 2020,1-17.
[9] Yao, Z.X., Li, J.X., Wang, K., Song, Y.N., Li, X., Experimental and numerical study on direct electrical heating for plug removal of subsea waxy crude pipelines, International Journal of Heat and Mass Transfer, 143, 2019, 118489.
[10] Xu, Y., Nie, X., Dai, Z., Liu, X.Y., Liu, Y., Cheng, Q., Numerical Simulation and Analysis of Phase Change Heat Transfer in Crude-Oil, Thermal Science, 25(2A), 2021, 1123-1134.
[11] Wang, H., An, C., Duan, M., Su, J., Transient thermal analysis of multilayer pipeline with phase-change material, Applied Thermal Engineering, 165, 2020, 114512.
[12] Góes, M.R.R.T., Teixeira, R.G.D., Tavares, F.W., Secchi, A.R., Wax appearance and prevention in two-phase flow using the multi-solid and drift-flux model, Journal of Petroleum Science, 177, 2019, 373-383.
[13] Wei, N., Pei, J., Li, H., Sun, W., Xue, J., Application of in-situ heat generation plugging removal agents in removing gas hydrate: A numerical study, Fuel, 323, 2022, 124397.
[14] Marques, L.C.C., Pedroso, C.A., Paixão, L.C.A., New Flow Assurance to Work Out Hydrate and Paraffin Blockages Problems in Deepwaters, Offshore Technology Conference, Houston, Texas, OTC-15190-MS, 2003.
[15] Khalil, C.N., Neumann, L.F., Santos, I., Linnard, C.A., Thermochemical Process to Remove Paraffin Deposits in Subsea Production Lines, Offshore Technology Conference, Houston, Texas, OTC-7575-MS, 1994.
[16] Marques, L.C.C., Pedroso, C.A., Neumann, L.F., A New Technique to Troubleshoot Gas Hydrates Buildup Problems in Subsea Christmas-Tress, SPE Annual Technical Conference and Exhibition, San Antonio, Texas, SPE-77572-MS, 2002.
[17] Tiwari, S., Verma, S.K., Karthik, R., Singh, A.K., Kumar, S., Singh, M., Kothiyal, M.D., In-Situ Heat Generation for Near Wellbore Asphaltene and Wax Remediation, International Petroleum Technology Conference, Doha, Qatar, IPTC-17681-MS, 2014.
[18] Evangelista, E.A., Chagas, C.M., Melo, J.A.F., Rocha, J.D.H., Filho, N.B., Marques, L.C.C., Removal of a Hydrate Plug from a Subsea Christmas-Tree Located in Ultra-Deep Waters with the Aid of a Heat-releasing Treating Fluid, Offshore Technology Conference, Houston, Texas, OTC-19730-MS, 2009.
[19] Pacheco, C.C., Orlande, H.R.B., Colaço, M.J., Leiroz, A.J.K., Estumano, D.C., Rocha, N.O., Khalil, C.N., Thermal Analysis of The Removal of Paraffin Blockages in Oil Pipelines via the Nitrogen Generating System (SGN), Second Thermal and Fluids Engineering Conference, Las Vegas, Nevada, 2017.
[20] Nguyen, D.A., Iwaniw, M.A., Fogler, H.S., Kinetics and mechanism of the reaction between ammonium and nitrite ions: experimental and theorical studies, Chemical Engineering Science, 58(19), 2003, 4351-4362.
[21] Voller, V., Cross. M., Accurate solutions of moving boundary problems using the enthalpy method, International Journal of Heat and Mass Transfer, 24(3), 1981, 545-556.
[22] Hahn, D.W., Ozisik, M.N., Heat Conduction, John Wiley & Sons, New Jersey, 2012.
[23] Senthil, R., Patel, A., Rao, R., Ganeriwal, S., Melting Behavior of Phase-Change Material in a Solar Vertical Energy Storage with Variable Length Fins added on the Heat Transfer Tube Surfaces, International Journal of Renewable Energy Development, 9(3), 2020, 361-367.
[24] Ashton, J.P., Kirspel, L.J., Nguyen, H.T., Credeur, D.J., In-Situ Heat System Stimulates Paraffinic-Crude Producers in Gulf of Mexico, SPE Production Engineering, 4(2), 1989, 157-160.